Skip to content

Woodworking

Can You Sand After Staining

Can You Sand After Staining : Explained in 6 Steps

In terms of completing a woodworking project, staining and sanding are two crucial steps that can effectively make the appearance. A smooth and even appearance is achievable by properly sanding a surface. But one common question that often arises: Can you sand after staining? The sanding between coats can significantly improve the appearance of the wood grain, and it may… Read More »Can You Sand After Staining : Explained in 6 Steps

How to Fix Finish on Wood Table From Nail Polish Remover

How to Fix Finish on Wood Table from Nail Polish Remover?

If you have spilled nail polish on your wooden table, you have probably experienced discomfort trying to remove the stain without damaging the table. There is no need to freak out in this circumstance. Is it possible that you spilled the remover on your wood table and wondered how to fix finish on wood table from nail polish remover? Luckily,… Read More »How to Fix Finish on Wood Table from Nail Polish Remover?

tung oil vs mineral oil butcher block

Tung Oil vs Mineral Oil Butcher Block: Why Confusion Arises?

A butcher block countertop comes with a large, flat surface to cut and process food. It is a type of slab made from hardwoods. With butcher block cutting boards, you can shred vegetables, slice meat, and more. If you don’t finish the Butcher Block, it will eventually dry out and crack. Tung Oil and Mineral Oil are both finishes that… Read More »Tung Oil vs Mineral Oil Butcher Block: Why Confusion Arises?

How to Check Tape Measure Accuracy

How to Check Tape Measure Accuracy | Just Follow 4 Steps

Accuracy is key when it comes to woodworking. Every woodworker uses a tape measure to obtain measurements for their project.  Your tap measure should be accurate. The accuracy of a tape measure can make or break your project. Even small inaccuracies can result in cutting too short, which means you’re going to have to sand and re-cut everything.  It’s not… Read More »How to Check Tape Measure Accuracy | Just Follow 4 Steps

Do You Wear a Face Shield When Bucking Wood

Do You Wear a Face Shield When Bucking Wood | 17 Reasons Why?

Every lumberjack’s main job is cutting down trees for lumber, but before a tree can be cut down, it must be bucked.  Bucking is the process of cutting the felled and delimbed tree into logs of a specific length. It is a physically demanding job that requires skill.  Chain saws are commonly used for bucking, but manual saws and axes… Read More »Do You Wear a Face Shield When Bucking Wood | 17 Reasons Why?

Benefits of Ventilated Face Shields for Turning

Benefits of Ventilated Face Shields for Turning | 12 Reasons

Woodturning is a good hobby and craft that many people enjoy. It can be an enriching experience, but it can also be harmful if you are not wearing the proper safety equipment. One of the most important pieces of safety gear for woodturners is a ventilated face shield. A ventilated face shield is a type of personal protective equipment used… Read More »Benefits of Ventilated Face Shields for Turning | 12 Reasons

Benefits of Using Carving Machines for Woodworking

Benefits of Using Carving Machines for Woodworking [Explained]

There was a time when craftspersons took particular pride in their wood carving skills. And patrons of this art would pay handsome amounts to get their hands on such handicrafts. However, the percentage of such buyers remains rather small, making it less sustainable for artisans to expend their time and energy for paltry compensation. Not to mention that they would… Read More »Benefits of Using Carving Machines for Woodworking [Explained]